Setting Up Your Tcp/Ip Properties For Dhcp - Alcatel-Lucent 9500 MXC User Manual

Chapter 2. Setting Up 9500 MXC CT
DHCP Ethernet Access Requirements

Setting Up Your TCP/IP Properties for DHCP

Introduction
Procedure
Vol. IV-2-10
DHCP Server function enabled, refer to:
• DHCP Ethernet Access Requirements on page 2-10
• Setting Up Your TCP/IP Properties for DHCP on page 2-10
A successful DHCP Ethernet connection from a CT PC requires the following:
• An industry-standard 10Base-T or 10/100Base-T LAN card installed on your
PC.
• DHCP enabled within the TCP/IP Properties window on your PC.
• DHCP server enabled on the 9500 MXC radio you are connecting to.
The DHCP server function is configured in the Configuration > Networking
screen. Refer to DHCP Server Function on page 10-13, Volume IV, Chapter 11.
Your CT PC must be configured to obtain an IP address automatically, which is
set within the Local Area Connection window on your PC.
This procedure is based on a PC running Windows 2000 PC; there may be small
differences with other versions of Windows.
1. Click on the LAN (network connection) icon in the System Tray, located in
the lower right corner of your PC screen.
LAN Icon
Or, from the Control Panel of your PC, select
>
Connections Local Area Connection
The Local Area Connection Status window is displayed.
2. Click .
Properties
3. Select
Internet Protocol (TCP/IP)
4. Ensure its associated box is ticked.
Network and Dial-up
.
.
Alcatel-Lucent