Alcatel-Lucent 9500 MXC User Manual page 427

Procedure for Configuring DAC 1x155o, 2x155o or 2x155e
3DB 23063 ADAA - Rev 004 July 2007
Typical DAC 2x155o Plug-ins Screen
Figure 7-9.
3
Item Description
1 Tributary type is fixed for STM1/OC3.
2 Link to circuits screen to select backplane bus. Bus type must be set to STM1.
3 Tributary Lines. User-defined entries for:
• Commissioned. Configured tribs must be ticked as commissioned. When
commissioned LOS alarms are raised if LOS is detected.
• Name. Each trib can be individually named/identified.
4 Icons indicate trib in/out status. Mouse-over for tooltip support.
1. From the Plug-ins screen, select the required module.
• For the optical DACs the tributary type is fixed for STM1/OC3.
• For the 2x155e DAC the tributary is fixed for STM1.
2. Check/set the Required Bus Type. An STM1 backplane bus is required. If not
set correctly, the Required Bus Type displays a warning icon. To reset, click
on Required Bus Type to go straight to the Circuits screen, and make the
change in the Bus Configuration selector.
3. Click (tick) Commissioned for the traffic-carrying tribs.
1
9500 MXC User Manual
2
4
Vol. IV-7-37