Alcatel-Lucent 9500 MXC User Manual page 424

Chapter 7. Node and Terminal Plug-ins
Procedure for E13/M13 Multiplexer Mode
Vol. IV-7-34
Rename, and typing. The default name is 'unnamed'.
6. Commit the configuration by clicking
Next Step: Go to the Circuits screen to configure circuit cross-connects. Refer to
Procedure for Configuring Circuits - Traffic on page 9-9, Volume IV, Chapter 9.
1. Select the E13/M13 mode.
2. Check/set the Required Bus Type. For the E13 selection an E1 backplane is
required. DS1 is required for M13. If not set correctly, Required Bus Type
displays a warning icon. To reset, click Required Bus Type to go straight to
the Circuits screen, and make the change in the Bus Configuration selector.
3. Click (tick) Commissioned for the traffic-carrying tribs.
• Traffic-carrying tribs must be commissioned.
• A commissioned trib displays an LOS alarm when input traffic is lost (no
valid E3 or DS3 connection).
• For protected DACs, LOS is a switching condition.
Trib Uncommissioned
• Traffic is not enabled.
• LOS alarms are suppressed.
• Received traffic causes an
uncommissioned traffic alarm.
4. Enter a tributary name by clicking in the
Trib names entered in this column are also displayed in the System/Controls
screen for the DAC.
5. Enter a name (optional - recommended) for the module by right-clicking in
the relevant DATA module in the System Summary screen, selecting
Rename, and typing. The default name is 'unnamed'.
6. Commit the configuration by clicking
Next Step: Go to the Circuits screen to configure circuit cross-connects. Refer to
Procedure for Configuring Circuits - Traffic on page 9-9, Volume IV, Chapter 9.
.
Send
Trib Commissioned
• Traffic is enabled.
• LOS alarms are raised if LOS is
detected. Front panel Status LED
indicates red for an LOS alarm.
field and typing (optional).
Name
.
Send
Alcatel-Lucent