Alcatel-Lucent 9500 MXC User Manual page 425

Procedure for 34 Mbps Transparent
3DB 23063 ADAA - Rev 004 July 2007
1. Select the E3 Transparent mode.
2. Check/set the Required Bus Type. For the E3 Transparent mode an E1
backplane bus is required. If not set correctly, the Required Bus Type displays
a warning icon. To reset, click on Required Bus Type to go straight to the
Circuits screen, and make the change in the Bus Configuration selector.
3. Click (tick) Commissioned for the traffic-carrying tribs.
• Traffic-carrying tribs must be commissioned.
• A commissioned trib displays an LOS alarm when input traffic is lost (no
valid E3 or DS3 connection).
• For protected DACs LOS is a switching condition
Trib Uncommissioned
• Traffic is not enabled.
• LOS alarms are suppressed.
• Received traffic causes an
uncommissioned traffic alarm.
4. Enter a tributary name by clicking in the
Trib names entered in this column are also displayed in the System Controls
screen for the same DAC.
5. Enter a name (optional - recommended) for the module by right-clicking in
the relevant DATA module in the System Summary screen, selecting
Rename, and typing. The default name is 'unnamed'.
6. Commit the configuration by clicking
Next Step: Go to the Circuits screen to configure circuit cross-connects. Refer to
Procedure for Configuring Circuits - Traffic on page 9-9, Volume IV, Chapter 9.
9500 MXC User Manual
Trib Commissioned
• Traffic is enabled.
• LOS alarms are raised if LOS is
detected. Front panel Status LED
indicates red for an LOS alarm.
field and typing (optional).
Name
.
Send
Vol. IV-7-35