Ncc User Interfaces - Alcatel-Lucent 9500 MXC User Manual

Chapter 3. 9500 MXC Nodes

NCC User Interfaces

NCC Front Panel Layout
Figure 3-10.
1 2
NCC Front Panel Descriptions
Table 3-7.
No Item/Label
1 Plug-in fastener
2 -48 Vdc
3 NMS 10/100Base-T
4 Ethernet orange LED
5 Ethernet green LED
6 Maint V.24
7 Test LED
Vol. II-3-20
Figure 3-10 shows the NCC front panel layout.
Table 3-7 on page 3-20 describes the front panel interfaces.
User access is also provided on the NCC PCB for:
• A fast acting 25A tubular ceramic fuse, located behind the -48 Vdc connector.
• CompactFlash card on the right side of the PCB.
4 5
3
Description
Finger-grip screw-type fastener and card pull (2).
2-pin polarized D-series 2W2C power connector with captive screw fasteners.
The four RJ-45 connectors provide Ethernet network management access. 9500
MXC CT login to these ports requires entry of the IP address for the INU/INUe.
Ports may also used to provide NMS connectivity to co-located 9500 MXC INU/
INUes and other Alcatel-Lucent and third party radios. Ports auto-resolve for
straight or cross-over cables.
Orange flashing LED indicates Ethernet receive activity. Off indicates no receive
activity. (Fitted to each RJ-45 NMS connector)
Green LED indicates connection of an Ethernet link. Off indicates no Ethernet
link connection. (Fitted to each RJ-45 NMS connector)
RJ-45 connector provides a V.24 serial interface option for CT access. Includes
a default IP address, which means knowledge of the INU/INUe IP address is not
required at login.
Provides indications of:
Off
Green
Orange flashing
INU/INUe power off.
Normal operation.
INU/INUe is in a test/diagnostic mode, for example,
loopbacks are set.
6 7
Alcatel-Lucent