Aux Front Panel - Alcatel-Lucent 9500 MXC User Manual

Chapter 3. 9500 MXC Nodes
Alarm Application

AUX Front Panel

AUX Front Panel Descriptions
Table 3-25.
No Item/Label
1 Plug-in fastener
2 Status LED
3 Alarm I/O
connector
4 Auxiliary
connector
Vol. II-3-70
These are maximum values, which require de-rating if the relay is to be
Note:
used for frequent-switch applications.
The contact voltage must be restricted to less than 60 Volts for
compliance with SELV regulations.
Maximum current specification applies up to 30 Volts
Events are mapped to outputs:
• Individual AUX alarm inputs or internal alarm events may be mapped to any
output within the network.
• Multiple input or internal events may be mapped to a common output.
• Mapping is achieved using IP addressing for the destination node, plus a slot
location and output number for the AUX plug-in.
AUX Front Panel Layout
Figure 3-43.
3
1 2
Description
Finger-grip screw-type fastener and plug-in pull (2).
Status LED provides indications of:
Off
Green
Orange flashing
Red
DSUB 15 connector. Refer to Appendix E for pinout and alarm I/O cable data.
DSUB 26 connector. Refer to Appendix E for pinout and AUX cable data.
4
INU power off
Normal operation
Configuration not supported, or software / hardware
1
incompatible
2
Critical alarm
Alcatel-Lucent