Alcatel-Lucent 9500 MXC User Manual page 452

Chapter 7. Node and Terminal Plug-ins
Vol. IV-7-62
Balanced aggregation weights are default applied, but where one of the
aggregated links is of different capacity, such as a 300 Mbps link aggregated
with a 150 Mbps link, the weighting on the 300 Mbps link should be set to
11, and to 5 on the 150 Mbps link.
The maximum Ethernet capacity supported on one INU/INUe is 300 Mbps
(311.04 Mbps). Using DAC GE link aggregation, two co-located INUs are
used to provide a 600 Mbps user interface (600 Mbps virtual link); three are
used to provide a 900 Mbps interface.
Figure 7-19 illustrates C1 and C2 aggregation. The default weighting
applied is 8/8. A typical application for this configuration is RAC 40 CCDP
XPIC operation of two 150 Mbps links on one 28 MHz or 30 MHz radio
channel.
Transparent Mode with C1 and C2 Aggregation
Figure 7-19.
Figure 7-20 illustrates C1 and P1 aggregation. The default weighting
T
applied is 8/8. A typical application for this configuration is same-path
operation of two 300 Mbps links. Note that on the partner link, link
aggregation is not configured, but Link Status Propagation should be
enabled.
More information: See Link Aggregation on page 7-76, and Link Status
Propagation Operational Characteristics on page 7-81.
Alcatel-Lucent