Setting Up Your Pc Tcp/Ip Properties - Alcatel-Lucent 9500 MXC User Manual

Chapter 2. Setting Up 9500 MXC CT

Setting Up Your PC TCP/IP Properties

Introduction
Procedure: Windows 2000
Vol. IV-2-6
Your CT PC must have a LAN-compatible address installed. Each
Node/Terminal in a 9500 MXC network has a unique network address, unless
connected on a LAN at the same site, so you must change your PC TCP/IP
settings each time you physically connect to a different Node/Terminal.
This requires configuration of your PC LAN card TCP/IP settings, so your PC is
recognized as a device on the 9500 MXC NMS LAN.
Procedures are provided for Windows 2000 and XP.
This procedure is based on a PC running Windows 2000 PC, there may be small
differences with other versions of Windows.
For guidance during this procedure refer to Example - Changing TCP/IP
Properties on page 2-8.
1. Click on the LAN (network connection) icon in the System Tray, located in
the lower right corner of your PC screen.
LAN Icon
Or, from the Control Panel of your PC, select
>
Connections Local Area Connection
The Local Area Connection Status window is displayed.
2. Click .
Properties
3. Select
Internet Protocol (TCP/IP)
4. Ensure its associated box is ticked.
Network and Dial-up
.
.
Alcatel-Lucent