Networking Screens - Alcatel-Lucent 9500 MXC User Manual

Chapter 10. Networking Configuration
Interface (Advanced) Address

Networking Screens

Vol. IV-10-4
• The Single IP address mode is only active if all single mode conditions are met
when the screen is refreshed. If conditions are not met then the interface address
mode is selected. As an example, if the radio is configured with a single IP
address and OSPF, and subsequently the network management system or
SNMP command is used to turn off OSPF on one interface, the single IP address
mode is no longer valid.
• All interfaces can be uniquely numbered, with entries for IP address, subnet
mask, interface, and next hop. Each interface can set for static or dynamic
routing. The dynamic routing options are OSPF, RIP1, RIP2.
• If new interfaces are added to the node, such as a new link, they must be
separately configured (any new interface is displayed with a default 1.0.0.1 IP
address).
The Networking screens provide configuration for IP addressing, dynamic or
static routing, and trap destinations. A DHCP server option can also be
configured.
For addressing and routing functions refer to:
• Configuring Single IP Addressing and Dynamic Routing on page 10-6
• Configuring Single IP Addressing and Static Routing on page 10-6
• Configuring Interface IP Addressing and Routing on page 10-9
• Configuring Trap Destinations on page 10-11
For the DHCP server option refer to DHCP Server Function on page 10-13.
Opening Screen
Networking opens to an IP addressing screen, which supports:
• Single IP addressing
• Selection of dynamic routing options of OSPF, RIP1 or RIP2.
• Enable DHCP server.
Tabs provide access to Interface Addressing, and to Static Routing or Trap
Destination screens.
On selection of OSPF routing, the option to Enable OSPF Area is un-greyed. If
Alcatel-Lucent