Chapter 11. 9500 Mxc Node And Terminal Alarm Actions; Alarm Actions Screen - Alcatel-Lucent 9500 MXC User Manual

Chapter 11. 9500 MXC Node and
Terminal Alarm Actions

Alarm Actions Screen

3DB 23063 ADAA - Rev 004 July 2007
The Alarm Actions screen supports mapping of alarms to/from an AUX module:
• TTL alarm inputs can be mapped to an output on the same AUX or to another
AUX within a 9500 MXC network.
• Internal alarms can be mapped to relay output on any AUX in a 9500 MXC
network.
Alarm mapping is achieved by identifying an alarm and configuring its
destination IP address, AUX and relay output port.
Refer to Alarm Actions Screen.
Figure 11-1 shows a typical Alarm Actions screen. It enables:
• Alarm mapping for all AUX plug-ins installed in a Node. For a Terminal
only the single Alarm I/O position is indicated.
• Mapping of alarm inputs to local and/or remote outputs.
• Mapping of local alarms (events) to local and/or remote outputs.
Inputs and/or alarms from multiple Nodes/Terminals can be mapped to a single,
common output on any Node/Terminal in the network.
Vol. IV-11-1