Alcatel-Lucent 9500 MXC User Manual page 339

3DB 23063 ADAA - Rev 004 July 2007
5. Click
Properties.
The Internet Protocol (TCP/IP) Properties window is displayed.
Before making any change to the settings in this window, record and retain the
existing settings, which may pertain to your company LAN.
6. Select
Use the following IP address
7. In the IP address field enter a LAN compatible IP address for the Node/
Terminal:
• The network portion of the IP address must be the same as the Node/
Terminal you are connecting to. The network portion is determined from the
subnet mask. Except in circumstances where sub-netting is used this
network portion will be indicated by subnet mask octets of 255.... In the
example above the network portion is 10.16 (subnet mask of 255.255.0.0).
• The host portion of the IP address must be set so that your CT PC is seen as
a different connection on the Node/Terminal LAN. It must NOT be set to the
same host number as the Node/Terminal you are connecting to.
• The subnet mask must be set to be the same as the Node/Terminal you are
connecting to.
Refer to Example - Changing TCP/IP Properties on page 2-8 for guidance.
8. To enable viewing of other 9500 MXC Nodes/Terminals on the network, set
the default gateway to be the same as the IP address of the Node/Terminal you
9500 MXC User Manual
.
Vol. IV-2-7