Agilent Technologies 8163A Programming Manual page 77

Interface/Instrument Behaviour Settings – The SYSTem Subsystem
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
:SYSTem:HELP:HEADers?
:SYSTem:HELP:HEADers?
Returns a list of GPIB commands.
none
Returns a list of GPIB commands
→
syst:help:head? Returns a list of all GPIB commands
:SYSTem:PRESet
:SYSTem:PRESet
Sets the mainframe and all installed modules to their standard settings. This command has
the same function as the Preset hardkey.
The following are not affected by this command:
• the GPIB (interface) state,
• the backlight and contrast of the display,
• the interface address,
• the output and error queues,
• the Service Request Enable register (SRE),
• the Status Byte (STB),
• the Standard Event Status Enable Mask (SESEM), and
• the Standard Event Status Register (SESR).
none
none
SYST:PRES
:SYSTem:TIME
:SYSTem:TIME<wsp><hour>,<minute>,<second>
Sets the instrument's internal time.
• the first value is the hour (0 .. 23),
• the second value is the minute, and
• the third value is the seconds.
none
syst:time 20,15,30
Instrument Setup and Status
77