Agilent Technologies 8163A Programming Manual page 178

Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
178
:TRIGger:CONFiguration?
:TRIGger:CONFiguration?
Returns the hardware trigger configuration.
none
DIS: Trigger connectors are disabled.
DEF: The Input Trigger Connector is activated, the incoming trigger response for
each slot ":TRIGger[n][:CHANnel[m]]:INPut" on page 173 determines how
each slot responds to an incoming trigger, all slot events (see
":TRIGger[n][:CHANnel[m]]:OUTPut" on page 176) can trigger the Output Trig-
ger Connector.
PASS: The same as DEFault but a trigger at the Input Trigger Connector generates a
trigger at the Output Trigger Connector automatically.
LOOP: The same as DEFault but a trigger at the Output Trigger Connector generates a
trigger at the Input Trigger Connector automatically.
CUSTOM: A custom configuration is active using either the command
":TRIGger:CONFiguration:EXTended" on page 179 or the
Agilent 816x VXIplug&play Instrument Driver. See "The Agilent 816x
VXIplug&play Instrument Driver" on page 213.
trig:conf? → DEF<END>
:TRIGger:CONFiguration:FPEDal
:TRIGger:CONFiguration:FPEDal<wsp>OFF|ON|0|1
Enables or disables the Input Trigger connector to be triggered using a Foot Pedal.
A boolean value:
none
trig:conf? → DEF<END>
:TRIGger:CONFiguration:FPEDal?
:TRIGger:CONFiguration:FPEDal?
Returns whether the Input Trigger connector can be triggered using a Foot Pedal.
none
A boolean value:
trig:conf? → DEF<END>
OFF or 0: foot pedal disabled (default)
ON or 1: foot pedal enabled
0: foot pedal disabled
1: foot pedal enabled
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Triggering - The TRIGger Subsystem