Agilent Technologies 8163A Programming Manual page 144

Measurement Operations & Settings
command:
syntax:
description:
N O T E
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
N O T E
parameters:
response:
example:
affects:
144
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt<wsp><start value>
[PM|NM|UM|MM|M]
Sets the starting point of the sweep.
Cannot be set while a sweep is running.
The wavelength at which the sweep starts as a float value.
If you specify no units in your command, meters are used as the default.
none
wav:swe:star 1500nm
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?[<wsp>MIN|MAX]
Returns the starting point of the sweep.
optional
The wavelength at which the sweep starts as a float value in meters.
→
wav:swe:star? +1.50000000E-006<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP<wsp><stop value>
[PM|NM|UM|MM|M]
Sets the end point of the sweep.
Cannot be set while a sweep is running.
The wavelength at which the sweep ends as a float value in meters.
If you specify no units in your command, meters are used as the default.
none
wav:swe:stop 1550nm
All tunable laser modules
Signal Generation – The SOURce Subsystem
MIN Returns the minimum start wavelength available.
This value is wavelength dependent.
MAX Returns the maximum start wavelength available.
This value is wavelength dependent.
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition