Agilent Technologies 8163A Programming Manual page 51

Specific Command Summary
Table 4 Specific Command Summary (continued)
Command
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep
:CHECkparams?
:CYCLes/?
:DWELl/?
:EXPectedtriggers?
:FLAG?
:LLOGging/?
:MODE/?
:PMAX?
:REPeat/?
:SOFTtrigger
:SPEed/?
:STARt/?
:STOP/?
[:STATe]/?
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep:STEP
:NEXT
:PREVious
[:WIDTh]/?
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Description
Returns whether sweep parameters set are consistent.
Sets or returns the number of cycles.
Sets or returns the dwell time.
Returns number of triggers (used to configure power meter).
Returns whether waiting for trigger, or logging data available.
Switches lambda logging on or off or queries the state of lambda
logging.
Sets or returns the sweep mode.
Returns the highest permissible power for a wavelength sweep.
Sets or returns the repeat mode.
Sends a soft trigger.
Sets or returns the speed for continuous sweeping.
Sets or returns the start point of the sweep.
Sets or returns the end point of the sweep.
Stops, starts, pauses or continues a wavelength sweep or returns
the the state of a sweep.
Performs the next sweep step.
Performs the previous sweep step again.
Sets or returns the width of the sweep step.
Specific Commands
Page
page 136
page 137
page 138
page 138
page 139
page 140
page 141
page 141
page 142
page 143
page 143
page 144
page 144
page 145
page 146
page 146
page 146
51