Agilent Technologies 8163A Programming Manual page 174

Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
affects:
dual sensors:
command:
syntax:
description:
N O T E
parameters:
N O T E
response:
example:
affects:
dual sensors:
174
:TRIGger[n][:CHANnel[m]]:INPut?
:TRIGger[n][:CHANnel[m]]:INPut?
Returns the incoming trigger response.
none
IGNore: Ignore incoming trigger.
SMEasure: Start a single measurement. If a measurement function is active, see
":SENSe[n][:CHANnel[m]]:FUNCtion:STATe" on page 100, one sample is
performed and the result is stored in the data array, see
":SENSe[n][:CHANnel[m]]:FUNCtion:RESult?" on page 97.
CMEasure: Start a complete measurement. If a measurement function is active, see
":SENSe[n][:CHANnel[m]]:FUNCtion:STATe" on page 100, a complete mea-
surement function is performed.
NEXTstep: Perform next step of a stepped sweep.
SWStart: Start a sweep.
→
trig1:inp? ign<END>
All tunable laser modules, power meters, and return loss modules, and attenuators with
power control.
Can only be sent to master channel, slave channel parameters are identical.
:TRIGger[n][:CHANnel[m]]:INPut:REARm
:TRIGger[n][:CHANnel[m]]:INPut:REARm<wsp>OFF|ON|0|1
Sets the arming response of a channel to an incoming trigger.
See Table Table 8 , for information on how this command affects triggering power
measurements.
A boolean value:
If you return to Local control, all modules return to the default setting.
none
trig1:inp:rearm 0
All Agilent 8163A/B series power meter modules, and Agilent 8161x series return loss mod-
ules.
Can only be sent to master channel, slave channel is also affected.
OFF or 0: trigger rearming disabled
ON or 1: trigger rearming enabled (default)
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Triggering - The TRIGger Subsystem