Agilent Technologies 8163A Programming Manual page 141

Signal Generation – The SOURce Subsystem
command:
syntax:
description:
N O T E
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE<wsp><mode>
Sets the sweep mode.
Cannot be set while a sweep is running.
STEPped:
MANual:
CONTinuous:
none
wav:swe:mode STEP
All tunable laser modules except Agilent 81649A, Agilent 81689A/B and 819x9A
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
Returns the sweep mode.
none
STEP:
MAN:
CONT:
→
wav:swe:mode? STEP<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?<wsp><start wavelength>,
<stop wavelength>
Returns the power to the highest permissible power for the selected wavelength sweep.
start wavelength: The wavelength at which the sweep starts as a float value.
stop wavelength: The wavelength at which the sweep starts as a float value.
The highest permissible power for the selected wavelength sweep as a float value.
wav:swe:pmax? 1540nm,1550nm → +3.5500000E-004<END>
All tunable laser modules
Stepped sweep mode
Manual sweep mode
Continuous sweep mode
Stepped sweep mode
Manual sweep mode
Continuous sweep mode
Measurement Operations & Settings
141