Agilent Technologies 8163A Programming Manual page 68

Instrument Setup and Status
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
68
:STATusn:OPERation[:EVENt]?
:STATusn:OPERation[:EVENt]?
Returns the Operational Slot Status Event Register (OSSER) of slot n.
none
The results for the individual slot events (a 16-bit signed integer value, where 0 ≤ value ≤
32767):
Bit Mnemonic
8-15 Not used
7 Slot n: offset (λ) type bit 2
6 Slot n: offset (λ) type bit 1
5 Slot n: offset (λ) has been enabled
4 Slot n: shutter has been opened
3 Slot n: Zeroing ongoing
2 Not used
1 Slot n: Coherence Control has been switched on
0 Slot n: Laser has been switched on
stat1:oper? → +0<END>
:STATusn:OPERation:CONDition?
:STATusn:OPERation:CONDition?
Returns the Operational Slot Status Condition Register of slot n.
none
The results for the individual slot events (a 16-bit signed integer value, where 0 ≤ value ≤
32767):
Bit Mnemonic
8-15 Not used
7 Slot n: offset (λ) type bit 2
6 Slot n: offset (λ) type bit 1
5 Slot n: offset (λ) enabled
4 Slot n: shutter open
3 Slot n: Zeroing ongoing
2 Not used
1 Slot n: Coherence Control is switched on
0 Slot n: Laser is switched on
stat1:oper:cond? → +0<END>
NOTE: Only attenuator bits 5 to 7 are used to show whether the offset feature is
used and which algorithm is used to calculate the wavelength dependent
offset.
Bit 5 states if the feature is enabled or disabled. Bits 6 and 7 are decoded as
shown below to say whether the attenuator uses saved, interpolated, or
extrapolated values.
Status Reporting – The STATus Subsystem
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Decimal Value
0
128
64
32
16
8
0
2
1
Decimal Value
0
128
64
32
16
8
0
2
1