Agilent Technologies 8163A Programming Manual page 46

Specific Commands
Table 4 Specific Command Summary (continued)
Command
:CORRection:COLLection:ZERO?
:PATH/?
:POWer/?
:POWer:CONTRol/?
:POWer:OFFSet/?
:POWer:OFFSet:POWermeter
:POWer:REFerence/?
:POWer:REFerence:POWermeter
:POWer:UNit/?
[:STATe]/?
:READ[n][:CHANnel[m]]
[:SCALar]:POWer[:DC]?
:POWer[:DC]:ALL?
:POWer[:DC]:ALL:CONFig?
[:SCALar]:RETurnloss?
[:SCALar]:MONitor?
:ROUTe[n]
[:CHANnel[m]]/?
[:CHANnel[m]]:CONFig?
[:CHANnel[m]]:CONFig:ROUTe?
46
Description
Queries the status of the last zero operation
Sets or returns the regulated path.
Sets or queries the output power value.
Sets or queries power control mode status
Sets or queries the power offset value.
Calculates power offset from measured power values
Sets or queries the reference power value.
Copies power value from power meter to attenuator module ref.
power parameter
Sets or queries power unit used (dBm or W)
Sets a source's or attenuators output terminals to open or closed
or returns the current status of a source's or attenuators output
terminals.
Reads the current power value from a sensor.
Reads all available power meter channels.
Return all the slot and channel number of every available power
meter channel.
Reads the current return loss value.
Returns the current power value from the monitor diode within a
return loss module.
Sets or returns the channel route between two ports.
Reads the switch configuration of an instrument.
Reads the allowed switch routes of an instrument.
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Specific Command Summary
Page
page 158
page 113
page 152
page 155
page 154
page 154
page 153
page 153
page 155
page 114
page 89
page 90
page 90
page 91
page 91
page 169
page 170
page 170