Agilent Technologies 8163A Programming Manual page 176

Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
affects:
dual sensors:
N O T E
command:
syntax:
description:
parameters:
response:
example:
affects:
dual sensors:
176
:TRIGger[n][:CHANnel[m]]:OUTPut
:TRIGger[n][:CHANnel[m]]:OUTPut
Specifies when an output trigger is generated and arms the module.
DISabled: Never.
AVGover: When averaging time period finishes.
MEASure: When averaging time period begins.
MODulation: For every leading edge of a digitally-modulated (TTL) signal
STFinished: When a sweep step finishes.
SWFinished: When sweep cycle finishes.
SWSTarted: When a sweep cycle starts.
none
trig1:outp dis
All tunable laser modules, Agilent 8163A/B series power meters, and Agilent 8161x series
return loss modules.
Can only be sent to master channel, slave channel is also affected.
In continuous mode, wav:swe:step:[widt] is used for triggering, see page 146.
:TRIGger[n][:CHANnel[m]]:OUTPut?
:TRIGger[n][:CHANnel[m]]:OUTPut?
Returns the condition that causes an output trigger.
none
DISabled: Never.
AVGover: When averaging time period finishes.
MEASure: When averaging time period begins.
MODulation: For every leading edge of a digitally-modulated (TTL) signal
STFinished: When a sweep step finishes.
SWFinished: When sweep cycle finishes.
SWSTarted: When a sweep cycle starts.
→
trig1:outp? dis<END>
All tunable laser modules, Agilent 8163A/B series power meters, and Agilent 8161x series
return loss modules.
Can only be sent to master channel, slave channel parameters are identical.
Triggering - The TRIGger Subsystem
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition