Configuring Named, Standard Acls; Creating Numbered, Standard Acls - HP 3500yl Series Access Security Manual

HP Switch(config)# show access-list Sample-List
Access Control Lists
Name: Sample-List
Type: Standard
Applied: No
SEQ Entry
-------------------------------------------------------------------------------
10 Action: permit
IP : 10.10.10.104
20 Action: deny (log)
IP : 10.10.10.1
30 Action: permit
IP : 0.0.0.0
Figure 10-15. Screen Output Listing the "Sample-List" ACL Content
Mask: 0.0.0.0
Mask: 0.0.0.255
Mask: 255.255.255.255

Creating Numbered, Standard ACLs

Use the following general steps to create or add to an numbered, standard
ACL:
1. Create a numbered, standard ACL by entering the first ACE in the list
2. Append a new ACE to the end of an existing, standard ACL
This section describes the commands for performing these steps. For other
IPv4 ACL topics, refer to the following:
Topic

configuring named, standard ACLs

configuring named, extended ACLs
configuring numbered, extended ACLs
applying or removing an ACL on an interface
deleting an ACL
editing an ACL
sequence numbering in ACLs
including remarks in an ACL
displaying ACL configuration data
creating or editing ACLs offline
enabling ACL "Deny" logging
IPv4 Access Control Lists (ACLs)
Configuring Standard ACLs
Note that each ACE is
automatically assigned a
sequence number.
Page
10-52
10-61
10-74
10-81
10-85
10-86
10-87
10-92
10-97
10-107
10-112
10-55