Port-Based Vlan Configuration Example - HP 3600 v2 series Configuration Manual

To do...
Enter interface view
or port group view
Configure the link
type of the ports as
hybrid
Assign the hybrid
ports to the specified
VLANs
Configure the PVID of
the hybrid ports
NOTE:
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
•
first.
• Before you assign a hybrid port to a VLAN, create the VLAN.
After configuring the PVID for a hybrid port, you must use the port hybrid vlan command to configure
•
the hybrid port to allow packets from the PVID to pass through, so that the egress port can forward
packets from the PVID.

Port-based VLAN configuration example

Network requirements
As shown in
Host A and Host C belong to Department A, and access the enterprise network through different
•
devices. Host B and Host D belong to Department B. They also access the enterprise network
through different devices.
To ensure communication security and avoid broadcast storms, VLANs are configured in the
•
enterprise network to isolate Layer 2 traffic of different departments. VLAN 100 is assigned to
Department A, and VLAN 200 is assigned to Department B.
Make sure that hosts within the same VLAN can communicate with each other. Host A can
•
communicate with Host C, and Host B can communicate with Host D.
Use the command...
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
Enter port group view:
port-group manual port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list { tagged |
untagged }
port hybrid pvid vlan vlan-id
Figure 40:
Remarks
Required
Use any command.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
Required
By default, all ports are access ports.
Required
By default, a hybrid port allows only packets
of VLAN 1 to pass through untagged.
Optional
By default, the PVID is VLAN 1.
123