Local Proxy Arp Configuration Example In Super Vlan - HP A7500 Series Configuration Manual

# Add GigabitEthernet 1/0/3, GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to VLAN 2.
Configure port isolation on Host A and Host B.
<SwitchB> system-view
[SwitchB] vlan 2
[SwitchB-vlan2] port GigabitEthernet 1/0/3
[SwitchB-vlan2] port GigabitEthernet 1/0/1
[SwitchB-vlan2] port GigabitEthernet 1/0/2
[SwitchB-vlan2] quit
[SwitchB] interface GigabitEthernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] port-isolate enable
[SwitchB-GigabitEthernet1/0/3] quit
[SwitchB] interface GigabitEthernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] port-isolate enable
[SwitchB-GigabitEthernet1/0/1] quit
Configure Switch A
2.
# Create VLAN 2, and add GigabitEthernet 1/0/2 to VLAN 2.
<SwitchA> system-view
[SwitchA] vlan 2
[SwitchA-vlan2] port GigabitEthernet 1/0/2
[SwitchA-vlan2] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 192.168.10.100 255.255.0.0
From Host A, ping Host B. The ping operation is unsuccessful because they are isolated at Layer 2.
# Configure local proxy ARP to allow communication between Host A and Host B at Layer 3.
[SwitchA-Vlan-interface2] local-proxy-arp enable
From Host A, ping Host B. The ping operation is successful after the configuration.

Local proxy ARP configuration example in super VLAN

Network requirements
Figure 1 1 shows a super VLAN, VLAN 10, with the interface IP address 192.168.10.100/16 and
sub-VLANs (VLAN 2 and VLAN 3). GigabitEthernet 1/0/2 belongs to VLAN 2 and GigabitEthernet
1/0/1 belongs to VLAN 3. Host A belongs to VLAN 2 and connects to GigabitEthernet 1/0/2 of the
switch. Host B belongs to VLAN 3 and connects to GigabitEthernet 1/0/1 of the switch.
As Host A and Host B belong to different Sub-VLANs, they are isolated at Layer 2. Configure local proxy
ARP on the switch to allow Layer 3 communication between Host A and Host B.
19