Additional Status Displays - HEIDENHAIN TNC 620 User Manual

Hide thumbs Also See for TNC 620:

Table of Contents

Introduction

Status displays

Additional status displays

The additional status displays contain detailed information on the

program run. This can be called in all operating modes except for

the Programming mode.

To switch on the additional status display

Call the soft key row for screen layout

Select the screen layout with additional status

display: In the right half of the screen, the TNC

shows the OVERVIEW status form

To select an additional status display

Toggle through the soft key rows until the STATUS

soft keys appear

Either select the additional status display directly

with the soft key, e.g. positions and coordinates;

use the switch-over soft keys to select the desired

Select the status displays described below as follows:

directly with the corresponding soft key

via the switchover soft keys

or by using the NEXT TAB key

Please note that some of the status information

described below is not available unless the

associated software option is enabled on your TNC.

HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016

Table of Contents