Workpiece Setup; Selecting The Correct Operating Mode; Clamping The Workpiece - HEIDENHAIN TNC 620 User Manual

1
First Steps with the TNC 620
1.6

Workpiece setup

1.6 Workpiece setup

Selecting the correct operating mode

Workpieces are set up in the Manual operation or Electronic
handwheel mode
Press the operating mode key for the TNC
to switch to Manual operation operating
modeManual operation
Further information on this topic
The operating mode Manual operation
Further Information:

Clamping the workpiece

Mount the workpiece with a fixture on the machine table. If you
have a 3-D touch probe on your machine, then you do not need to
clamp the workpiece parallel to the axes.
If you do not have a 3-D touch probe available, you have to align the
workpiece so that it is fixed with its edges parallel to the machine
axes.
Further information on this topic
Setting datums with a 3-D touch probe
Further Information:
(option number 17)", page 533
Setting datums without 3-D touch probe
Further Information:
probe", page 511
74
"Moving the machine axes", page 485
"Datum setting with a 3-D touch probe
"Datum setting without a 3-D touch
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016