HEIDENHAIN TNC 620 User Manual page 668

18
Tables and Overviews
18.5 Functions of the TNC 620 and the iTNC 530 compared
Comparison: Touch probe cycles in the Manual
operation and Electronic handwheel modes of
operationElectronic handwheel
Cycle
Touch-probe table for managing 3-D touch probes
Calibrating the effective length
Calibrating the effective radius
Measuring a basic rotation using a line
Setting the datum on any axis
Setting a corner as datum
Setting a circle center as datum
Setting a center line as datum
Measuring a basic rotation using two holes/cylindrical studs
Setting the datum using four holes/cylindrical studs
Setting the circle center using three holes/cylindrical studs
Determine and offset misalignment of a plane
Support of mechanical touch probes by manually capturing the current
position
Write measurement values to the preset table
Write measurement values to the datum table
668
TNC 620
X
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
X, option 17
By soft key or
hard key
X, option 17
X, option 17
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
iTNC 530
–
X
X
X
X
X
X
X
X
X
X
–
By hard key
X
X