HEIDENHAIN TNC 620 User Manual page 169

4.2 Adding comments
Application
You can add comments to a part program to explain program steps
or make general notes.
Depending on the machine parameter lineBreak
(no. 105404), the TNC displays comments that can
no longer be shown entirely on the screen, shows
these in several lines or the character >> appears on
the screen.
The last character in a comment block must not have
any tilde(~).
You have the following possibilities for adding comments.
Entering comments during programming
Enter the data for an NC block, then press the semicolon key ;
on the alphabetic keyboard—the TNC displays the dialog prompt
Comment?
Enter your comment and conclude the block by pressing the
END key
Inserting comments after program entry
Select the block to which a comment is to be added
Select the last word in the block with the right arrow key, then
press the semicolon key (;): The TNC displays the dialog prompt
COMMENT?
Enter your comment and conclude the block by pressing the
END key
Entering a comment in a separate block
Select the block after which the comment is to be inserted
Initiate the programming dialog with the semicolon key (;) on
the alphabetic keyboard
Enter your comment and conclude the block by pressing the
END key
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Adding comments
4
4.2
169