HEIDENHAIN TNC 620 User Manual page 335

9.7 Checking and changing Q parameters
Procedure
You can check Q parameters in all operating modes, and also edit
them.
If you are in a program run, interrupt it if required (e.g. by
pressing the NC STOP key and the INTERNAL STOP soft key) or
stop the test run
To call the Q parameter functions, press the Q
INFO soft key or the Q key
The TNC lists all parameters and their current
values. Use the arrow keys or the GOTO key to
select the desired parameter.
If you would like to change the value, press the
EDIT CURRENT FIELD soft key. Enter a new file
name and confirm with ENT
To leave the value unchanged, press the PRESENT
VALUE soft key or end the dialog with the END key
The parameters used by the TNC internally or in
cycles are provided with comments.
If you want to check or edit local, global or string
parameters, press the SHOW PARAMETERS Q QL
QR QS soft key. The TNC then displays the specific
parameter type. The functions previously described
also apply.
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Checking and changing Q parameters
9
9.7
335