HEIDENHAIN TNC 620 User Manual page 570

16
Test Run and Program Run
16.4 Test run
Execute test run
If the central tool file is active, a tool table must be
active (status S) to conduct a test run. Select a tool
table via the file manager in the Test run mode of
operation.
You can select any preset table (status S) for the test run.
After RESET + START, line 0 of the temporarily loaded preset
table automatically displays the momentarily active datum from
Preset.pr (execution). Line 0 is selected when starting the test run
until you define another datum in the NC program. All datums from
lines > 0 are read by the control from the selected preset table of
the test run.
With the BLANK IN WORK SPACE function, you activate working
space monitoring for the test run.
Further Information:
space (option 20)", page 566
Operating mode: Press the Test run key
Call the file manager with the PGM MGT key and
select the file you wish to test
The TNC then displays the following soft keys:
Soft key
You can interrupt the test run and continue it again at any point
—even within a fixed cycle. In order to continue the test, the
following actions must not be performed:
Selecting another block with the arrow keys or the GOTO key
Making changes to the program
Selecting a new program
570
"Show the workpiece blank in the working
Functions
Reset the blank form, reset the previous tool
data and test the entire program
Test the entire program
Test each NC block individually
Executes the Test run until block N
Halt test run (soft key only appears once you
have started the test run)
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016