HEIDENHAIN TNC 620 User Manual page 513

14.7 Using a 3-D touch probe (option 17)
Overview
The following touch probe cycles are available in the Manual
operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
Make sure during probing that the axis angles
match the set tilt angles. The control checks
this automatically if the chkTiltingAxes machine
parameter (no. 204601) is activated.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Soft Function
key
Calibrating the 3-D Touch
Probe
Measuring a 3-D basic rotation
by probing a plane
Measuring a basic rotation
using a line
Setting the datum on any axis
Set a corner as preset
Set a circle center as preset
Setting the centerline as
datum
Touch probe system data
management
For more information about the touch probe table,
refer to the User's Manual for Cycle Programming
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Using a 3-D touch probe (option 17) 14.7
Page
521
531
529
533
534
535
538
See Cycle
Programming
User's Manual
14
513