HEIDENHAIN TNC 620 User Manual page 162

3
Fundamentals, file management
3.4 Working with the file manager
Data transfer to or from an external data carrier
Before you can transfer data to an external data
medium, you must set up the data interface.
Further Information:
page 603
Depending on the data transfer software you use,
problems can occur occasionally when you transmit
data over a serial interface. They can be overcome by
repeating the transmission.
To call the file manager, press the PGM MGT key.
Select the screen layout for data transfer: press
the WINDOW soft key.
Use the arrow keys to move the cursor to the file you wish to
transfer:
Moves the cursor up and down within a window
Moves the cursor from the right to the left
window, and vice versa
If you wish to copy from the TNC to the external data medium,
move the highlight in the left window to the file to be transferred.
If you wish to copy from the external data medium to the TNC,
move the highlight in the right window to the file to be transferred.
Select another drive or directory: Press the SHOW
TREE soft key
Use the arrow keys to select the desired directory
Select the desired file: Press the SHOW FILES soft
key
Use the arrow keys to select the file
Transfer a single file: Press the COPY soft key
Confirm with the OK soft key or with the ENT key. A status
window appears on the TNC, informing about the copying
progress, or
Stop transfer: Press the WINDOW soft key. The
TNC displays the standard file manager window
again
162
"Setting up data interfaces",
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016