HEIDENHAIN TNC 620 User Manual page 301

7
DXF converter (option 42) 7.3
Rapid selection of hole positions via icon
Select the mode for choosing a machining
position: The Graphics window is active for
position selection
Select the icon: The TNC opens a window in
which you can filter the holes by size
Configure the filter settings if required and click
the OK button to confirm: The TNC loads the
selected positions into the List View window
(displays a point symbol).
Further Information: "Filter settings", page 302
If necessary you can also deselect elements that
you already selected by clicking the element in the
graphic window again, but this time while pressing
the CTRL key. Alternatively, select the element
in the List View window and press DEL. You can
deselect all selected elements by clicking the icon
Save the selected machining positions to the
clipboard of the TNC so that you can then insert
them as a positioning block with cycle call in a
plain-language program, or
To save the selected machining positions in a point
file: The TNC displays a pop-up window for you
to enter any file name, the file type and target
directory.
Confirm the entry: The TNC saves the contour
program to the selected directory
If you want to select more machining positions,
press the Cancel Selected Elements icon and
select as described above
301
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016