HEIDENHAIN TNC 620 User Manual page 598

Hide thumbs Also See for TNC 620:

Table of Contents

MOD Functions

Machine settings

Tool usage file

The tool usage test function must be enabled by

your machine manufacturer. Refer to your machine

With the MOD function Tool-usage file you can select whether the

TNC never, once, or always creates a tool usage file.

Generate a tool usage file:

In the MOD menu select the Machine settings groupMachine

Select the Tool-usage file menuTool-usage file

Select the desired setting for the operating modes Program

Run, Full Sequence/Single Block and Test run

Press the APPLY soft keyAPPLY

Press the OK soft key

Select kinematics

The Kinematics selection function must be enabled

and adapted by the machine manufacturer.

Refer to your machine manual.

You can use this function to test programs whose kinematics

does not match the active machine kinematics. If your machine

manufacturer saved different kinematic configurations in your

machine, you can activate one of these kinematics configurations

with the MOD function. When you select a kinematics model for

the test run this does not affect machine kinematics.

Danger of collision!

When you switch the kinematics model for machine

operation, the TNC implements all of subsequent

movements with modified kinematics.

Ensure that you have selected the correct kinematics

in the test run for checking your workpiece.

HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016

Chapters

Table of Contents