HEIDENHAIN TNC 620 User Manual page 474

12
Multiple axismachining
12.6 Running CAM programs
Possibilities for intervention on the control
Cycle 32 TOLERANCE is available for the influencing of CAM
programs directly on the TNC. Also note the information in the
functional description for Cycle 32. Also note the interactions with
the chord error defined in the CAM system.
Further information:
Refer to your machine manual.
Some machine tool builders provide an additional
cycle for adapting the behavior of the machine to
the respective machining operation, such as Cycle
332 Tuning. Cycle 332 can be used to modify filter
settings, acceleration settings, and jerk settings.
NC example blocks, Cycle 32
34 CYCL DEF 32.0 TOLERANCE
35 CYCL DEF 32.1 T0.05
36 CYCL DEF 32.2 HSC MODE:1 TA3
ADP motion control
Refer to your machine manual.
This feature must be enabled and adapted by the
machine tool builder.
An insufficient quality of data in NC programs created on CAM
systems frequently causes inferior surface quality of the milled
workpieces. The ADP (Advanced Dynamic Prediction) feature
expands the conventional look-ahead of the permissible maximum
feed rate profile and optimizes the motion control of the feed axes
during milling. This enables clean surfaces with short machining
times to be cut, even with a strongly fluctuating distribution
of points in adjacent tool paths. This significantly reduces or
eliminates the reworking complexity.
These are the most important benefits of ADP:
Symmetrical feed-rate behavior on forward and backward paths
with bidirectional milling
Uniform feed rate curves with adjacent cutter paths
Improved reaction to negative effects (e.g. short, step-like
stages, coarse chord tolerances, heavily rounded block end-
point coordinates) in NC programs generated by CAM system
Precise compliance to dynamic characteristics even in difficult
conditions
474
Cycle Programing User's Manual
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016