HEIDENHAIN TNC 620 User Manual page 626

18
Tables and Overviews
18.1 Machine-specific user parameters
Parameter list
Parameter settings
DisplaySettings
Settings for screen display
Sequence of displayed axes
[0] to [7]
Type of position display in position window
Type of position display in status display
Definition of decimal separator for position display
Display of feed rate in operating mode Manual operation
Display of spindle position in the position display
Show or hide soft key preset table
Font size with program display
626
Depends on available axes
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
.
at axis key: Only display feed rate if axis direction key is pressed
always minimum: Always display feed rate
during closed loop: Only display spindle position if spindle is in position control
during closed loop and M5: Display spindle position if spindle is in position control
and with M5
True: Soft key preset table is not displayed
False: Display soft key preset table
FONT_APPLICATION_SMALL
FONT_APPLICATION_MEDIUM
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016