HEIDENHAIN TNC 620 User Manual page 219

Column Meaning
WTIME
Tool-usage time in seconds (total usage
time between tool changes)
RAD Tool radius R + Oversize of tool radius DR
from the tool table. (in mm)
BLOCK Block number in which the T block was
programmed
PATH
TOKEN = TOOL: Path name of the active
main program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T
Tool number with tool index
OVRMAX
Maximum feed rate override that occurred
during machining. The TNC enters the
value 100 (%) during the test run
OVRMIN
Minimum feed rate override that occurred
during machining. During Test Run the TNC
enters the value –1
NAMEPROG
0: The tool number is programmed
1: The tool name is programmed
The TNC saves the tool usage times in a separate file with the
extension pgmname.I.T.DEP. This file is not visible unless the
machine parameter dependentFiles (no. 122101) is set to MANUAL
There are two ways to run a tool usage test for a pallet file:
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet
Using a tool usage test
Before starting a program in the Program Run, Full Sequence/
Single Block operating modes, you can use the TOOL USAGE and
TOOL USAGE TEST soft keys to check whether the tools being used
in the selected program are available and have sufficient remaining
service life. The TNC then compares the actual service-life values in
the tool table with the nominal values from the tool usage file.
After you have pressed the TOOL USAGE TEST soft key, the TNC
displays the result of the tool usage test in a pop-up window. To
close the pop-up window, press the ENT key.
You can query the tool usage test with the D18 ID975 NR1
function.
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Tool data 5.2
219
5