HEIDENHAIN TNC 620 User Manual page 447

The PLANE function: Tilting the working plane (software option 8) 12.2
Input parameters
X coordinate of 1st plane point?: X coordinate
P1X of the 1st plane point
Y coordinate of 1st plane point?: Y coordinate
P1Y of the 1st plane point
Z coordinate of 1st plane point: Z coordinate P1Z
of the 1st plane point
X coordinate of 2nd plane point?: X coordinate
P2X of the 2nd. plane point
Y coordinate of 2nd plane point?: Y coordinate
P2Y of the 2nd plane point
Z coordinate of 2nd plane point?: Z coordinate
P2Z of the 2nd plane point
X coordinate of 3rd plane point?: X coordinate
P3X of the 3rd plane point
Y coordinate of 3rd plane point?: Y coordinate
P3Y of the 3rd plane point
Z coordinate of 3rd plane point?: Z coordinate
P3Z of the 3rd plane point
Continue with the positioning properties
Further Information:
behavior of the PLANE function", page 451
NC block
N50 PLANE POINTS P1X+0 P1Y+0 P1Z+20 P2X+30 P2Y+31 P2Z+20
P3X+0 P3Y+41 P3Z+32.5 .....*
Abbreviations used
Abbreviation Meaning
POINTS
Points
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
"Specifying the positioning
12
447