HEIDENHAIN TNC 620 User Manual page 134

3
Fundamentals, file management
3.2 Opening programs and entering
Soft key/key Function
Delete the selected word
NO
ENT
Insert the block that you last edited or deleted
Inserting blocks at any desired location
Select the block after which you want to insert a new block and
initiate the dialog
Save changes
The control normally saves changes automatically if you switch the
operating mode or if you select the file manager. If you deliberately
want to save changes to the program, proceed as follows:
Select the soft-key row with the saving functions
Press the STORE soft key for the TNC to save all
changes made since the last time you saved the
program
Saving a program to a new file
You can save the contents of the currently active program under a
different program name. Proceed as follows:
Select the soft-key row with the saving functions
Press the SAVE AS soft key: The TNC opens a
window in which you can enter the directory and
the new file name
Select the target directory if required with the
SWITCH soft key
Enter the file name
Confirm with the OK soft key or the ENT key, or
press the CANCEL soft key to abort
The file saved with SAVE AS is now also found in the
file management under LAST FILES.
134
Set the selected word to zero
Erase an incorrect number
Delete the (clearable) error message
Delete the selected block
Erase cycles and program sections
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016