Running The First Program; Selecting The Correct Operating Mode; Choosing The Program You Want To Run; Start The Program - HEIDENHAIN TNC 620 User Manual

1
First Steps with the TNC 620
1.7

Running the first program

1.7 Running the first program

Selecting the correct operating mode

You can run programs either in the Program run, single block or
the Program run, full sequence mode:
Press the operating mode key: Die TNC changes
to operating mode Program run, single block, and
the TNC executes the NC program block by block.
You have to confirm each block with the NC START
KEY
Press the operating mode key: Die TNC changes
to operating mode Program run, full sequence,
and the TNC runs the program after NC start-
up to a program interruption or to the end of the
program
Further information on this topic
Operating modes of the TNC
Further Information:
Executing a program
Further Information:

Choosing the program you want to run

Press the PGM MGT key: The TNC opens the file
manager
Press the LAST FILES soft key: The TNC opens a
pop-up window with the most recently selected
files
Use the arrow keys if required to select the
program you want to run. Load with the ENT key
Further information on this topic
File management
Further Information:
page 141

Start the program

Press the NC START key: The TNC runs the active
program
Further information on this topic
Executing a program
Further Information:
76
"Modes of operation", page 81
"Program run", page 572
"Working with the file manager",
"Program run", page 572
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016