HEIDENHAIN TNC 620 User Manual page 562

16
Test Run and Program Run
16.1 Graphics (option 20)
Plan view
Select the plan view in the Test run operating mode:
Press the FURTHER VIEW OPTIONS soft key
Press the PLAN VIEW soft key
Select plan view in the operating modes Program run, single
block and Program run, full sequence:
Press the GRAPHICS soft key
Press the PLAN VIEW soft key
Projection in three planes
The simulation shows three sectional planes and a 3-D model,
similar to a technical drawing.
Select projection in three planes in the Test run operating mode:
Press the FURTHER VIEW OPTIONS soft key
Press the VIEW ON 3 PLANES soft key
Select projection in three planes in the operating modes Program
run, single block and Program run, full sequence:
Press the GRAPHICS soft key
Press the VIEW ON 3 PLANES soft key
562
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016