First Steps with the TNC 620 | Running the first program
1.7
Running the first program
Selecting the correct operating mode
You can run programs either in the Program run, single block or
the Program run, full sequence mode:
Press the operating mode key
The control switches to the operating mode
Program run, single block, and executes the NC
program block by block.
You have to confirm each block with the
NC start key
Press the operating mode key
The control switches to the operating mode
Program run, full sequence, and executes
the program after NC start up to a program
interruption or to the end of the program
Further information on this topic
Operating modes of the control
Further information:
Executing a program
Further information:
Choosing the program you want to run
Press the PGM MGT key
The control opens the file manager.
Press the LAST FILES soft key
The control opens a pop-up window with the
most recently selected files.
Use the arrow keys if required to select the
program you want to run. Load with the ENT key
Further information on this topic
File management
Further information:
page 171
Starting the program
Press the NC start key
The control runs the active program.
Further information on this topic
Executing a program
Further information:
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
"Modes of operation", page 91
"Program run", page 717
"Working with the file manager",
"Program run", page 717
1
85