Cisco Catalyst 4500 Series Configuration Manual page 1048

show vlan mapping
show vlan mapping
Use the show vlan mapping privileged EXEC command to display information about VLAN mapping
on trunk ports.
Syntax Description interface interface-id
| begin
| exclude
| include
expression
Command Default None
Command Modes Privileged EXEC
Command History Release
12.2(54)SG
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is a sample output from the show vlan mapping command:
Switch# show vlan mapping
Interface Fa0/5:
VLANs on wire
------------------
default QinQ
Interface Fa0/2:
VLANs on wire
------------------
2
This is a sample output from the show vlan mapping command for an interface:
Switch# show vlan mapping interface fa0/6
Interface fa0/6:
VLAN on wire
1
12,16-18
*
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-1000
show vlan mapping [interface interface-id] [ | {begin | exclude | include} expression]
Modification
This command was introduced on the Catalyst 4500 series switch.
Translated VLAN
---------------
Translated VLAN
---------------
104
Translated VLAN
(Optional) Displays VLAN mapping information for the specified
interface.
(Optional) Displays begins with the line that matches the expression.
(Optional) Displays excludes lines that match the expression.
(Optional) Displays includes lines that match the specified expression.
Specifies an expression in the output to use as a reference point.
Operation
--------------
1 selective QinQ
Operation
--------------
1-to-1 mapping
Operation
11 1-to-1 mapping
100 selective QinQ
101 default QinQ
Chapter 2
OL-30934-01