Rsp Redundancy And Switchover - Cisco ASR 9000 Series User Configuration Manual

Managing the Router Hardware
Field
Subtype
Inst
Current SW Version
Upg/Dng?

RSP Redundancy and Switchover

This section describes RSP redundancy and switchover commands and issues.
Establishing RSP Redundancy
Your router has two slots for RSPs: RSP0 and RSP1 (see
RSP0 and RSP1 in an 8-Slot Chassis, on page
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Description
FPD type. Can be one of the following types:
• fabldr—Fabric downloader
• fpga1—Field-programmable gate array
• fpga2—Field-programmable gate array 2
• fpga3—Field-programmable gate array 3
• fpga4—Field-programmable gate array 4
• fpga5—Field-programmable gate array 5
• rommonA—Read-only memory monitor A
• rommon—Read-only memory monitor B
FPD instance. The FPD instance uniquely identifies
an FPD and is used by the FPD process to register an
FPD.
Currently running FPD image version.
Specifies whether an FPD upgrade or downgrade is
required. A downgrade is required in rare cases when
the version of the FPD image has a higher major
revision than the version of the FPD image in the
current Cisco IOS XR software package.
Figure 3: Redundant Set of RSPs Installed in Slots
116). RSP0 is the slot on the left, facing the front of the chassis,
RSP Redundancy and Switchover
115