Provisioning T1 Outputs - Symmetricom TimeProvider 5000 User Manual

4. Type
set output crc port2 enable
5. Type
set output ssm port2 enable
6. Type
set output ssm-bit port2 4
7. Type
set output state port2 enable
CAS Frame Type
To provision Port 1 as an output port with a frametype of CAS, CRC enabled,
SSM-bit of 4, and to enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port1 output
3. Type
set output frametype port1 cas
4. Type
set output crc port1 enable
5. Type
set output ssm port1 enable
6. Type
set output ssm-bit port1 5
7. Type
set output state port1 enable

Provisioning T1 Outputs

Use the following procedures to provision I/O-1 or I/O-2 (RJ-48 ports) as a T1
output.
Note: The T1 ports on t
module
which meet the G.703 mask for impedance of 120 ohms, balanced.
1544kHz Frame Type
To provision Port 1 as an output port with a frametype of 1544kHz, SSM disabled,
and to enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port1 output
3. Type
set output frametype port1 freq1544khz
098-00028-000 Revision F – May, 2012
and press Enter.
he 090-50314-01 version of the I/O
can also be configured as E1 and 2048 kHz inputs or outputs
and press Enter.
Provisioning the Programmable E1/T1 Outputs
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
TimeProvider 5000 User's Guide 327
Chapter 4 Provisioning