Symmetricom TimeProvider 5000 User Manual page 262

Chapter 3
TimeProvider 5000 CLI Command Set
Use this command to add a new VLAN configuration to an Ethernet port and
provision its Host, Mask, and Gateway IP addresses. This command also can be
used to modify or delete an existing VLAN configuration. Each VLAN must be
configured with its own IP address on a separate subnet.
Note: If the Ethernet interface is not to be part of a VLAN, use the
command
IOC ports, ETH1 and ETH2, can support up to 500 VLANs each

Bonded IOC ports can support 500 VLANs total, using the ETH1 VLAN

configuration.
The first 16 VLANs (Index = 1 to 16) can be configured with default gateway

The non-fixed VLANs (up to 484) can be configured with one static route.

Ethernet expansion shelf supports 1 VLAN per port.

When a non-fixed VLAN is removed, the route will be automatically deleted.
Command Syntax:
To provision the VLAN mode for the specified port or expansion shelf:

set vlan-mode {ioc1-1 | ioc1-2 | exp[0-9]} {enable |
disable}
To add a fixed VLAN for the specified port:

set vlan-config add {ioc1-1 | ioc1-2} index {1 thru 16}
vlan-id <vlan-id> priority <priority> address <ip-address>
netmask <mask> gateway <gateway>
Note: If a gateway router is not required, then set the gateway value
to the special value of 0.0.0.0
Note: When using VLANs, the network administrator should
configure the Ethernet switches and/or router to handle the VLANs.
To add a non-fixed VLAN:

set vlan-config add {ioc1-1 | ioc1-2} non-fixed vlan-id
<vlan-id> priority <priority> address <ip-address> next-hop
<ip-addr> dest-network <network-prefix/prefix-length>
To modify the IP address, netmask, or gateway for an existing fixed VLAN

configuration on the specified port:
262 TimeProvider 5000 User's Guide
set ip
, on page 160 to provision the IP addresses instead.
098-00028-000 Revision F – May, 2012