Symmetricom TimeProvider 5000 User Manual page 156

Chapter 3
TimeProvider 5000 CLI Command Set
show ioc-state
This command displays the state of both the active and standby
cannot assume the active or standby state, the state indicates NOT
IOC module
AVAILABLE.
Command Syntax:
show ioc-state
Example:
tp5000> show ioc-state
Response:
---------------------------------
|Module ID
|---------------|---------------|
|ioc1
|...............|...............|
|ioc2
---------------------------------
Level : User, Config, and Admin
set ioc-state
Use this command to provision the standby module to become the active module.
IOC1 refers the
to the right of the IMC.
Command Syntax:
set ioc-state {ioc1 | ioc2} active
Example:
tp5000> set ioc-state ioc2 active
Remarks :
Switchover to the standby IOC will be prohibited if the standby IOC has alarms of
higher severity than the active IOC, or if the standby IOC is still in warm-up. Check
system status and alarms if the command fails.
Level : Config and Admin only
156 TimeProvider 5000 User's Guide
|State
|active
|standby
to the left of the IMC and IOC2 refers to the
IOC module
IOC module
|
|
|
098-00028-000 Revision F – May, 2012
. If either
IOC module