Symmetricom TimeProvider 5000 User Manual page 421

Table A-1. System Notification Messages (Continued)
Comp
Description
Configuration data
sync error
Voltage to RTE
microprocessor out
of specified range
GNSS/GPS signal
low
PTP client dropped
from client list
Table A-2
(See for
Secondary Index Info)
PTP client added to
client list
Table A-2
(See for
Secondary Index Info)
PTP client IP
address to be
changed
Table A-2
(See for
Secondary Index Info)
PTP client changed
to new address
Table A-2
(See for
Secondary Index Info)
PTP client list
refreshed
FPGA in failed state
098-00028-000 Revision F – May, 2012
Event
MsgLevel
ID ID
IOC 76 Major
IOC 77 Major
IMC 78 Minor
IOC 79 Event
IOC 80 Event
IOC 81 Event
IOC 82 Event
IOC 83 Event
IOC 84 Critical
Trans-
MsgText
itory
No Configuration data
sync error
Configuration data
sync error cleared
No RTE <x.x V or xMHz
EFC> out of range
RTE voltage out of
range cleared
No GNSS/GPS signal
low
GNSS/GPS signal
normal
No PTP client dropped
from client list
No PTP client added to
client list
No PTP client IP
address to be
changed
No PTP client changed
to new address
No PTP client list
refreshed
No FPGA in failed state Reboot IOC with
TimeProvider 5000 User's Guide 419
Appendix A System Messages
System Notification Messages
Corrective Action
Reboot IOC that is
showing alarm. If
alarm is still
present, replace
IOC module.
Replace IOC that is
reporting alarm.
Check GNSS/GPS
None required
None required
None required
None required
None required
alarm. If alarm
persists, then
replace IOC