Ptp Management Commands; Managing Ptp Clients - Symmetricom TimeProvider 5000 User Manual

Managing PTP Clients

The TimeProvider 5000 GrandMaster supports four different aspects of PTP
management for TimeProvider 500 clients. The "set ptp-node" command is used to
provision the acceptable master clocks, reboot, and upgrade the firmware for TP500
clients through the TP5000 GrandMaster. See
status" command is used to monitor TP500 client performance. The TimeProvider
5000 also offers a means to monitor alarm and event information for TimeProvider
500 clients using Simple Network Management Protocol (SNMP).
Figure 5-2.

PTP Management Commands

098-00028-000 Revision F – May, 2012
Managing PTP Clients
Figure 5-2. The "show ptp-node
TimeProvider 5000 User's Guide 365
Chapter 5 Operating