Symmetricom TimeProvider 5000 User Manual page 202

Chapter 3
TimeProvider 5000 CLI Command Set
show pql-ssm
This command displays the Priority Quality Level (PQL) values for reference input
signal types. The PQL corresponds to the "ssm-value" parameter that is used with
the "set input" command. The PQL is a representation of traceability for the signal
presented at the input ports, where a PQL value of 15 represents an invalid SSM. If
SSM is disabled for an input port, then the TP5000 will use the user-assigned
SSM-value (PQL) for that input port.
Note:
reference while clock was in normal lock state.
Command Syntax:
show pql-ssm
Example:
tp5000> show pql-ssm
Response:
Option 1 Table
---------------------------------------------------------
| Option 1 SSM hex | Clock QL
|------------------|-------------|----------------|-----|
| 0x02
|..................|.............|................|.....|
| 0x00
|..................|.............|................|.....|
| 0x04
|..................|.............|................|.....|
| 0x04
|..................|.............|................|.....|
| 0x08
|..................|.............|................|.....|
| 0x0B
|..................|.............|................|.....|
| 0x0F
|..................|.............|................|.....|
| Others(or absent)| Invalid
---------------------------------------------------------
Option 2 Table
202 TimeProvider 5000 User's Guide
SSM during bridging will be the last SSM value of input
| QL-PRC
| STU
| QL-SSU-A
| Type I
| QL-SSU-B
| QL-SEC/EEC1 | 104
| QL-DNU
| PTP clockClass | PQL |
| 84 | 1
| 82 | 2
| 90 | 3
| 90 | 4
| 96 | 6
| 7
| 110 | 9
| n/a | 15
098-00028-000 Revision F – May, 2012
|
|
|
|
|
|
|
|