Table of Contents
Advertisement
Allow both the standby IOC and the IMC to fully reboot and return to service.
Once you are able to log back into the TimeProvider 5000, issue the command
"
show status
incorrect - this is temporary. Please ignore this.
Issue the command "
may be alarms present that are invalid- this is temporary. Please ignore this. Wait
until the standby IOC changes from standby warm-up to standby.
7. Make standby IOC active with the command "
(where
x
8. There will be a temporary gap in the PTP flow. To minimize the gap, immediately
restart IP interfaces on IOC:
a. Use the command "
b. Use the command "
9. Verify IOC switch state with the command "
the current standby IOC is running the previous firmware version with "
inventory
10.Reboot standby IOC with "
position, either 1 or 2). Immediately after the prompt returns, reboot IMC with
"reboot imc".
11.After the standby IOC module and IMC module return to service, log into the
TimeProvider 5000 and issue the command "
the modules are now at 2.0.4 revision.
12.Issue the command "
used must be disabled. Choose the appropriate commands from the list below for
the input references that need to be disabled:
set gnss state disable
set gps state disable
set input state port1 disable
set input state port2 disable
set pps-tod state port1 disable
set pps-tod state port2 disable
13.Verify that the TimeProvider 5000 is running correctly by issuing commands
"
show status
098-00028-000 Revision F – May, 2012
". The current reference input and the phase offset fields may be
show alarm
is the current standby IOC, either 1 or 2).
set ip ioc1-1 restart
set ip ioc1-2 restart
".
reboot iocx
show ref
", "
", and "
show alarm
Chapter 6 Maintenance and Troubleshooting
". At this point in the upgrade procedure, there
set ioc-state iocx active
"
"
show ioc-state
" (where the x is the standby IOC
show inventory
". All of the input references that are not being
show inventory
Upgrading the Firmware
". Also verify that
show
". Make sure all of
".
TimeProvider 5000 User's Guide 395
"
Advertisement
Chapters
Table of Contents
Troubleshooting
